Sinjimoru Full Cover Glass touch TPU Film
6H Tempered Glass
Glass Touch
Fast and Accurate Recognition
Try Sinjimoru Full Cover Glass Touch TPU Film now.
Glass Touch with Quick Recognition
Soft-touch tempered glass, the product increases the recognition speed with UV curing coating.
High Hardness Scratch Resistant
When cured, the hardness increases to 5-6H, and the film prevents scratches on the screen as tempered glass does.
Full Edge Cover Restoration
The curved edge covers the entire screen, and the daily scratch that occurs during use is recovered within 1 minute to up to 48 hours.
Main Features
Compatible models
HOW TO USE
1. Remove the dust from the phone screen with the enclosed wet wipes, dry wipes, and dust removal sticker.
2. After removing the adhesive layer of the handle ①, hold the handles ②, ④, and place them on the screen in the correct position.
3. Hold the handle ②, lift it vertically up to the central guideline, then push it up with the slider from the center to the top of the phone.
4. Hold handle ③, lift it vertically up to the central guideline, then slide down from the center to the lower part of the phone with the slider.
5. Finally, hold the handle ④ and remove it from the bottom to the top, then push the screen left and right with the slider.
Important Notice
1. We do not offer compensation for the damage that occurred due to careless use or insufficient knowledge about the product.
2. The size of the screen protector is slightly smaller than the phone screen in order to guarantee compatibility with Sinjimoru phone cases and that is not a defect.
3. If you repetitively clean the film surface with alcohol or acetone, fingerprint prevention may weaken.
4. If you don't follow the guide, there is a possibility of film stretch or excessive air bubbles when attaching. Be sure to watch the film attachment guide or video to attach them in order.
5. The solid line that appears immediately after attachment is not a defect and disappears within 24 hours when stored at room temperature.
6. If the film is not attached right after opening, the film may harden and pops up when attaching.
7. This product is a film that cures over time after being opened and attached. The curing time and maximum hardness are proportional to the amount of transmitted UV light.
8. If you reset the Face ID and fingerprint after attaching the product, recognition will perfectly perform.
9. Any damage made before curing will not be repaired after curing.